Output Channel Selector Kit: Difference between revisions
Jump to navigation
Jump to search
IVSWikiBlue (talk | contribs) |
IVSWikiBlue (talk | contribs) |
||
| Line 22: | Line 22: | ||
[[File:Db-rc2st wiring.png|link=https://ipivs.com/wiki/images/a/ad/Db-rc2st_wiring.png]] | [[File:Db-rc2st wiring.png|link=https://ipivs.com/wiki/images/a/ad/Db-rc2st_wiring.png]] | ||
==Wiring the ST-RX2== | ==Wiring the ST-RX2== | ||
# | #Determine above the ceiling where the ST-RX2 will be mounted | ||
# | #Connect the lines ran from the DB-RC2ST as shown | ||
[[File:St-RX2 wiring2.png|link=https://ipivs.com/wiki/images/e/e1/St-RX2_wiring2.png]] | |||
''Note:'' The ST-RX2 and DB-RC2ST will draw from the same power source and can be connected together using a terminal block | |||
==Device Data Sheets== | ==Device Data Sheets== | ||
Revision as of 16:20, 15 February 2021
Wiring Diagram
Required Parts and Tools
- RDL ST-RX2
- RDL D-RT2ST
- RDL 24 V power supply
- (1) terminal block
- Shielded Stranded 22/2 + ground Wire
- (1) Single Gang mud ring or triple gang if paired with observation audio kit(s)
- Stud finder
- Fish tape or Glow Rods
- Drywall Saw
- Small Screwdriver
- Face plate screws
Mounting the Button
- Using a stud finder, scan the mounting location of the Verifact D ensure the microphone is not mounted on a stud.
- Using a pencil, mark out where the switching button will be located
- Cut a hole into the drywall, large enough to fit the mud ring into it securely.
- Cut a hole above the drop ceiling to fish lines (if necessary)
- Using fish tape or glow rods, fish 3 lines of 22/2, two for signal control and one for power. (shown below)
Wiring the ST-RX2
- Determine above the ceiling where the ST-RX2 will be mounted
- Connect the lines ran from the DB-RC2ST as shown
Note: The ST-RX2 and DB-RC2ST will draw from the same power source and can be connected together using a terminal block