OWI Overhead Speaker Installation Instructions: Difference between revisions
Jump to navigation
Jump to search
IVSWikiBlue (talk | contribs) |
IVSWikiBlue (talk | contribs) No edit summary |
||
| Line 2: | Line 2: | ||
* OWI Amplified Overhead Speaker | * OWI Amplified Overhead Speaker | ||
* 3.5mm audio cable | * 3.5mm audio cable | ||
* 22/2 shielded audio cable | |||
* 18/2 low voltage cable | * 18/2 low voltage cable | ||
* Drywall saw | |||
* B Connectors | * B Connectors | ||
* Wire Stripper | * Wire Stripper | ||
| Line 10: | Line 12: | ||
==Installation Instructions== | ==Installation Instructions== | ||
===Mounting Instructions=== | |||
#Determine the most optimal placement for the OWI speaker | |||
#:''Note:'' Avoid mounting adjacent to microphones to prevent signal looping | |||
#Remove the ceiling tile to which the speaker will be mounted | |||
#When removing the speaker from its packaging, note that there is a cutting template for the speaker. Ensure to remove the excess along the dashed line | |||
#Using the cutting template, trace the template centered in the ceiling tile | |||
#:[[file]] | |||
#Using a drywall saw, carefully cut out the mounting location | |||
#:[[file]] | |||
===Connecting to Power=== | |||
===Connecting the Camera=== | |||
#Once your camera is installed, locate the AUDIO OUT on your camera. | #Once your camera is installed, locate the AUDIO OUT on your camera. | ||
#Strip the jacket of the 22/2 cable revealing the red, black, and bare wires inside. | #Strip the jacket of the 22/2 cable revealing the red, black, and bare wires inside. | ||
Revision as of 16:24, 12 May 2020
Required Parts And Tools
- OWI Amplified Overhead Speaker
- 3.5mm audio cable
- 22/2 shielded audio cable
- 18/2 low voltage cable
- Drywall saw
- B Connectors
- Wire Stripper
- 22/2 audio cable
- Fish Tape or Glow Rods
- Electrical Tape
Installation Instructions
Mounting Instructions
- Determine the most optimal placement for the OWI speaker
- Note: Avoid mounting adjacent to microphones to prevent signal looping
- Remove the ceiling tile to which the speaker will be mounted
- When removing the speaker from its packaging, note that there is a cutting template for the speaker. Ensure to remove the excess along the dashed line
- Using the cutting template, trace the template centered in the ceiling tile
- Using a drywall saw, carefully cut out the mounting location
Connecting to Power
Connecting the Camera
- Once your camera is installed, locate the AUDIO OUT on your camera.
- Strip the jacket of the 22/2 cable revealing the red, black, and bare wires inside.
- Cut away the plastic surrounding the cable inside. Strip away a small piece of the red and black jackets revealing the bare copper wire.
- Wire the black and bare to the - and the red to the + of the AUDIO OUT of the phoenix connector.
- Run the 22/2 cable from the camera to the AMP2SIC5, wiring your red wire to the + phoenix connection and black to the - connection of the LINE INPUT of the AMP2SIC5
- Run the 18/2 from the AMP2SIC5 to its designated power outlet.