Start/Stop Button

Hardware Configuration

First wire the button to the desired camera's IO phoenix connector. If you are using our buttons, the wires should be connected to the back of the button as shown in the diagram below.

Button	Phoenix Connector
NO	Pin 1
+	Pin 2
C	Pin 3
-	Pin 4

We recommend wiring the buttons using 22/4 as shown below:

Software Configuration

You will need to log into the software with admin rights and navigate to the Admin Section then click on rooms.

1. ) Select a room
2. ) Check the Use I/O box
3. ) Select what camera the I/O wiring is tied into
4. ) Select a user - All I/O recordings in that room will be considered authored by that user
5. ) If it is a PTZ camera you can have the camera move to a preset at the start of the recording
6. ) Press Save to enable I/O button recordings