5525 Wall Mount Instructions: Difference between revisions

Revision as of 20:07, 17 August 2020

Locate the AXIS T91E61 Wall Mount.
This is the recommended wall mount by IVS. Verify the model of your mount here
Locate the AXIS T94A01D Pendant Kit.
Connect the two parts and tighten them together by hand.
Continue tightening, by hand, until you cannot rotate the pendant kit anymore.
Using a T20 bit, tighten down the screw located inside the pendant kit.
Locate the mounting plate.
This part comes packed with the AXIS M5525.
Take the camera disk and line up the 3 pegs on the top with the three holes on the pendant kit.
Put the pegs in the holes and rotate the disk counter clockwise until the pieces prevent you from turning more.
Using a T30 bit, tighten the three screws on top of the pendant kit, securing it to the camera disk.
[[File:|350px|link=]]

@@ Line 11: / Line 11: @@
 #:[[File:ScrewLock.png|250px|link=https://ipivs.com/wiki/images/d/de/ScrewLock.png]]
 #Locate the mounting plate.
-#:"This part comes packed with the AXIS M5525."
+#:''This part comes packed with the AXIS M5525.''
 #:[[File:5525 Disk.png|250px|link=https://ipivs.com/wiki/images/f/f8/5525_Disk.png]]
-#Take the disk and line up the 3 pegs on the top with the three holes on the pendant
+#Take the camera disk and line up the 3 pegs on the top with the three holes on the pendant kit.
 #:[[File:Camera disk2.png|500px|link=https://ipivs.com/wiki/images/6/6e/Camera_disk2.png]]
-#
+#Put the pegs in the holes and rotate the disk counter clockwise until the pieces prevent you from turning more.
 #:[[File:Camera disk.png|400px|link=https://ipivs.com/wiki/images/5/56/Camera_disk.png]]
+#Using a T30 bit, tighten the three screws on top of the pendant kit, securing it to the camera disk.
+#:[[File:Large screws3.png|300px|link=https://ipivs.com/wiki/images/0/0f/Large_screws3.png]]
 #
-#:[[File:|250px|link=]]
+#:[[File:|350px|link=]]