OWI Overhead Speaker Installation Instructions: Difference between revisions

From IVS Wiki
Jump to navigation Jump to search
Created page with "==Required Parts And Tools== * OWI Amplified Overhead Speaker * 3.5mm audio cable * 18/2 low voltage cable * B Connectors * Wire Stripper * 22/2 audio cable * Fish Tape..."
 
Line 8: Line 8:
* Fish Tape or Glow Rods
* Fish Tape or Glow Rods
* Electrical Tape
* Electrical Tape
==Installation Instructions==
#Once your camera is installed, locate the AUDIO OUT on your camera.
#Strip the jacket of the 22/2 cable revealing the red, black, and bare wires inside.
#Cut away the plastic surrounding the cable inside. Strip away a small piece of the red and black jackets revealing the bare copper wire.
#Wire the black and bare to the - and the red to the + of the AUDIO OUT of the phoenix connector.
#Run the 22/2 cable from the camera to the AMP2SIC5, wiring your red wire to the + phoenix connection and black to the - connection of the LINE INPUT of the AMP2SIC5
#Run the 18/2 from the AMP2SIC5 to its designated power outlet.

Revision as of 21:54, 6 May 2020

Required Parts And Tools

  • OWI Amplified Overhead Speaker
  • 3.5mm audio cable
  • 18/2 low voltage cable
  • B Connectors
  • Wire Stripper
  • 22/2 audio cable
  • Fish Tape or Glow Rods
  • Electrical Tape

Installation Instructions

  1. Once your camera is installed, locate the AUDIO OUT on your camera.
  2. Strip the jacket of the 22/2 cable revealing the red, black, and bare wires inside.
  3. Cut away the plastic surrounding the cable inside. Strip away a small piece of the red and black jackets revealing the bare copper wire.
  4. Wire the black and bare to the - and the red to the + of the AUDIO OUT of the phoenix connector.
  5. Run the 22/2 cable from the camera to the AMP2SIC5, wiring your red wire to the + phoenix connection and black to the - connection of the LINE INPUT of the AMP2SIC5
  6. Run the 18/2 from the AMP2SIC5 to its designated power outlet.